2020?

[Groman]

Why hasn't this model been included on the website? I have seen a few around, but not been able to find any specs.

[Blazer Johnnie]

It was accidently omitted from the site. I should be on there by next week.

Blazer Johnnie

[Groman]

Thanks.

Much better looking site BTW.

[natelauscg]

groman this is nate. I have a 2020 if you have any questions ill answer them if i can.

[Groman]

Thanks Nate.
What are you pushing yours with? And what kind of numbers do you see?
Most I have seen have 150s on them. I have only seen one with a 200 HPDI.

[bayspec]

Groman,

I have the 2020 with the 200 HPDI. I also test drove the 2020 with the 150 Yami 4-stroke. Both engines were green during dealer break-in, but the numbers during initial testing with two people and light fuel were as follows: The 150F had good hole shot and topped out @ about 50 mph turning 5800-5900 rpm. Running about 4500 rpm showed about 35 mph. The 200Z topped out at 58 mph turning 5800 rpm and ran 40 mph at 4200 rpm. Needless to say the hole shot was great. I went with the 200z for the additional umph and only 7 pounds of weight gain. In addition, I was trying to get about 40 mph and in the 4K rpm range. With full fuel and fishing load, the 200z is showing about 40 mph at 4300 rpm and a top speed @ 55 mph @ 5600 rpm. These are numbers on a still green engine with less than 10 hours. The 150F was turning the new 19" pitch Yamaha Reliance prop and the 200z was turning the 21" prop. Hope this helps anyone out there.

[Groman]

bayspec, thanks for the information!

[Groman]

bayspec,
One more question if you don't mind. Do you have a jackplate on your boat? If so what kind?
I guess that is more than one question

[bayspec]

Yes, it is a 10" Bob's Hydraulic jack plate. Fortunately, just one answer.

[natelauscg]

Groman,

I have the 150 4-stroke yamaha on my boat with a manual jack plate, I got it up to 52mph with another person and 3/4 fuel on calm water and 19 pitch prop.