Need help with chimewalk

[Bear51]

Ihave a 2008 190 prov with 200 opti 25 temp prop. Can someone tell me where to start with mtor height and how much of the chimewalk that I can expect to be able to adjust out and what speed I should expect to see

[Rebel1]

You need to start at about 1 3/4in. below the pad and come up till you lose water pressure or gain rpm but lose speed. This combo should see about 73-75 depending on load, set-up, and driver ability.

[Bear51]

At what point on the motor do I take my measurement at the point on the nosecone or somewhere else.

[blazerbrian]

Take your measurement at the center of the prop shaft